SINGER W106 - Manual (Page 5)

02/14/2008
1. Take-up
2. Pressure Control
3. Top Thread Guides
4. Creative Embroidery
Control
5. Stitch Width Control
6. Bobbin Winder
7. Hand Wheel
8. Stitch Length Control
9. Reverse Button
10. Bobbin Winder Tension
Discs
11. Feed Dog Height
Control
12. Needle Plate
13. Presser Foot
14. Slide Plate
15. Thumb Screw
16. Check Spring
17. Face Cover
18. Tension Control
19. Needle Clamp
20. Spool Pins
21. Light Switch
22. Presser Foot Lever
23. Thread Cutter
24. Feed Dog
25. Head Hinge Holes
26. Motor
27. Belt Cover
28. Clutch Nut
Always at its highest position when beginning or ending
sewing.
For regulating the pressure on fabric.
For le^ing thread to tension control for sewing
For precise adjustment of zigzag stitch width as well as
tapering.
For setting stitch width
For winding thread on bobbin.
For the control of the up and down movement of the
needle.
For selecting stitch length between no feeding and
about 6 stitches per inch.
For easy back tacking to lock thread ends.
For providing proper tension on thread when bobbin
winding.
For regulating feed dog height for various materials and
types of sewing.
With guide lines for sewing accuracy.
For holding fabric when sewing.
For opening an
dccess for bobbin and bobbin case.
For tightening pre^r foot in place on presser bar.
For automatic precise adjustment of flow of upper thread.
Htnp-open type for replacement of light bulb and oiling.
For regulating the amount of tension on upper thread.
For holding needle in place In the slot of needle bar.
For holding ^ools, preventing over-spin of spools.
For turning on or off the light inside
face cover.
For lifting or lowering presser bar and presser foot.
For convenience to cut both upper and lower threads
after sewing.
.
Diamond point to move fabric accurately.
For instaliation of machine head into portable ca» or
cabinet
110— I t s Vote, for running machine.
For covering motor belt.
For releasing movement of the needle bar In order to wind
bobbin.