Adjusting bobbin winder, Adjusting and motor belt – SINGER W106 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
02/14/2008
ADJUSTING BOBBIN WINDER
It may be necessary to adjust the position
of bobbin winder tension discs at the
right front bed plate to align to the
bobbin on bobbin winder, especially,
when thread winds unevenly on bobbin.
If the thread winds unevenly on bobbin
as shown (A), loosen set screw and move
the bobbin winder tension discs slightly
to the left. If the thread winds as shown
(Bj, move the discs slightly to the right.
IA|
Ml
N
ADJUSTING
AND
MOTOR BELT
CHANGING
To adjust motor belt, loosen the screw
(Aj securing the motor bracket (Bj and
move bracket up to loosen belt and down
to tighten. When proper adjustment is
attained, tighten screw securely.
To remove motor belt;
• Remove top cover
• Loosen screw (Aj and move motor
bracket (B) to its highest position.
• Slip belt off motor pulley and then
over hand wheel.
• Replace motor belt by slipping it over
hand wheel and then over motor pulley.
• Adjust motor belt tension as noted
above.