Attachment foot, Edgestitcher, Attachment foot edgestitcher – SINGER W106 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
02/14/2008
ATTACHMENT FOOT
In order to attach binder, edpstitchtr and thi
hemmers, it is necessary to removt th* priiltl'
foot and replace it with the attachment foot.
Mount binder, edgestitcher or hemmwi ^
sliding the attachment to the left as far as
possible and tightening the screw.
The mounting slot enables you to sew as close to
or as far away from the edge as desired. Just
move the attachment to the correct position
before tightening the mounting screw.
EDGESTITCHER
The edgestitcher is used in making dainty lace
insertions, edgings and piping.
The slots in the edgestitcher serve as guides in
sewing together various pieces of material. If you
want to sew lace, lace and embroidery, or lace
and tucked strips together, place the piece of
material that will be on top in slot 1 and the
lower fabric in slot 4. For instance, if you are
sewing lace edging to a finished edge of fabric,
place the fabric in slot 1 and the lace in slot 4.
Be sure to draw the lace and material under the
needle and back of the edgestitcher so that the
feed will carry it backward as you stitch. Hold
the fabric in the left hand and the lace in the
right, being sure the fabric overlaps the lace
''■lightly.
Rick-rack can be sewn to the edge of the material
in the same manner.
To trim with wide piping place the fabric in slot
4, and the fold of the piping to the left in slot 3,
for a narrow piping place fabric in slot 2 and the
folded edge of the piping to the right in slot 3.
Slot 5 may be used as a guide in stitching a
French seam.