Setting the needle, Winding the bobbin, Setting the needle winding the bobbin -8 – SINGER W2137 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SETTING THE NEEDLE
See Fig. 3. Raise the needle bar A to its highest point, turn
ing wheel toward you by hand. Then loosen the needle clamp
screw B and the needle clamp C will open. Place needle 'flat
side to back in the needle clamp and push it upward as far
as it will go into the needle clamp hole, fastening the needle
clamp securely with a screw driver.
WINDING THE BOBBIN
Disengage
the
hand
wheel
i
Fig.
4./
from
the
stitching
mechanism
by
turning
the
clutch
toward
you
or
counterclock
wise. Place a spool of thread on one of the spool pins, lead
thread
under
the
handle
and
through
the
upper
thread
guide
on the arm, and down through the tension disc (11, Fig. 5) at
the base of the machine. Run end of thread through a hole in
the
bobbin
edge
and
place
bobbin
on
spindle
B
of
winder
4, fitting the notch on bobbin over small pin on spindle. Push
Fig. 4