SINGER W159 - Manual (Page 11)

THREADING THE MACHINE (See Fig. 10 & 11)
]) Turn balance wheel toward you to raise take-up lever (F, Fig. 10)
to its highest point.
2) Place spool of thread on upper spool pin
3) Lead thread through arm thread guide B1 to B2, Fig. 10.
4) Down and around thread tension dial C from right to left.
5) Into the check spring D over thread tension dial.
6) Then down under thread bar E.
7) Up into take-up lever F from right to left.
8) Down into lower face plate thread guide G on face plate.
9) Through the needle bar thread guide H.
10) And into needle from left to right. Pull three or four inches of
thread through needle.
Hold the end of upper thread loosely and turn balance wheel toward you untO the needle goes all the way down and
comes back up. A loop (Fig. 11) will be formed over the lower thread which then can be pulled out straight. Place both
thread ends under the slot of the presser foot and draw toward the back of the machine, leaving both threads three or four
inches long.
Fig. 13
10