Replacing the sude plate, Changing the light bulb – SINGER 717 Scholastic User Manual
Page 43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REPLACING THE SUDE PLATE
You will not have any occasion to remove the
slide plate. However, If it should accidentally
become disengaged from the machine, it is
easily replaced.
• Raise the presser foot and make sure needle
is in its highest position,
• Place slide plate in slide way with the front
edge close to, but not covering, the retain
ing spring (as shown}.
• With a small screwdriver, lift each end of the
spring into each of the side grooves on the
m6erslde of the plate.
• Draw the plate gently toward you and fully
engage the spring.
• Close slide plate.
V
Replacing the Slide Plate
CHANGING THE LIGHT BULB
Make sure you have disconnected power-
line plug from electrical outlet
Removing Bulb. With thumb of right hand,
push in and down on tab of light lens and
lower the light bracket. Do not attempt to
unscrew the bulb. Press it up into the
socket and at the same time turn bulb over
in direction shown to unlock the bulb pin.
Replacing Bulb. Press new bulb into
socket, with bulb pin entering slot of
socket, and turn it over in direction shown
to lock bulb in position. Push entire as
sembly up until it snaps In position.
41