SINGER 7050 - Manual (Page 16)

USING THE NEEDLE THREADER (P)
To help in threading the machine needle, use the needle threader as follows:
• Thread machine and draw 4" (10 cm)
of thread down to the needle.
• Lower presser foot lifter.
• Holding needle threader as shown with
your right hand, position U-shaped part
of threader under bar of needle clamp.
• Snap threader up onto bar.
• Swing threader back just far enough to clear
the needle.
• Slide threader as far to the left as it will
go.
• Be sure guide (1) is against the left side
of the needle.
• Bring metal hook of threader forward,
through the eye of the needle.
• Holding 3" (7.5 cm) of thread between
your fingers, guide thread into metal
hook. Release thread.
• Holding threader with right hand, draw
metal hook and thread backwards
through eye of the needle.
• To remove needle threader, slide it to
the right, and off bar of needle clamp.
• Carefully unhook thread from needle
threader.