Lcd clock operating instructions, Lcd clock operation instructions – SINGER 7050 User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LCD CLOCK OPERATING INSTRUCTIONS
IMPORTANT:
Disconnect the machine power before you
remove the clock cover.
REMOVING AND REPLACING THE
COVER:
Removal:
Press down at point “A” on
the clock cover and pull
towards you.
Replacement: Fit the clock cover into place
by putting the tab at “B” into
place and then pushing the
tab at ‘A” into place.
READING THE TIME:
Hours and minutes are displayed with blinking
colons.
SETTING THE TIME:
Hour:
Press the “S” button three times.
The hour followed by either an
“A” for AM or a “P” for PM will
appear. Press the “D” button to
advance the time.
Minute:
Press the “S” button once again.
A stationary colon followed by the
minutes will appear. Press the
“D” button to advance the
minutes.
Important: Press the “S” button once more
and then press the “D” button to
start the colons blinking and the
clock running.
CHANGING THE BATTERY:
Removal:
• Slide the battery retainer
down to remove the battery.
Replacement: • Place the battery in area
“F”. Make sure the “+”
side of the battery is facing
you.
• Slide the battery retainer
up to position “G”.
• Make sure the notch on the
battery retainer is under the
dotted position of the
diagram.
Battery:
Use a 1.5V 23-115 battery or
its equivalent. (LR-44 or A76)
43