SINGER 7050 - Manual (Page 19)

INSERTING A WOUND BOBBIN
When you want to sew with a bobbin that is already wound, insert it following the
instructions below.
• Raise presser foot.
• Turn hand wheel toward you until
needle is in its highest position.
a Open slide plate completely, and
remove bobbin.
1. Pull 4" (10cm) of thread from replace­
ment bobbin and insert bobbin, with
rings facing up, into case.
2. Holding bobbin in place, guide thread
into notch (1).
3. Bring thread around and past point #2.
4. Holding bobbin thread on outside, leave
slide plate open.
• Follow directions for “Raising Bobbin
Thread”, on page 18.
17