Section 6 caring for your machine, Remo vino and repla cing bobbin case, Caring for your machine – SINGER 7050 User Manual
Page 43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 6
CARING FOR YOUR MACHINE
REMO VINO AND REPLA CING BOBBIN CASE
CAUTION: Before cleaning or adjusting
the machine, remove plug from the socket
outlet.
• Raise presser foot and needle.
• Open slide plate and remove bobbin.
To remove the bobbin case, the needle
plate must be removed first.
• Lift needle plate (1) from right corner
and slide out from under foot.
TO REMOVE BOBBIN CASE
•
Push lever (2) toward you until it stops,
and hold in this position.
• Lift bobbin case up and guide it out
toward you, as shown.
TO REPLACE BOBBIN CASE
•
Push lever (2) toward you until it stops,
and hold in this position.
• Guide bobbin case into place, making
sure block (3) is all the way under metal
bracket
(4).
• Return lever (2) to locking position over
top of bobbin case.
NOTE: After locking case in place, be
sure it is not tight, but can move slightly.
• To replace needle plate, slide it
under pin (5) and push it to the left.
• Press needle plate down in place.
• Insert bobbin and close slide plate.
41