Warning, Setting up the thread guide holder – SINGER 14U244 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Warning:

Be sure that the electrical voltage of the electric outlet (wall receptacle) is the same as the rated
voltage of the motor.

* Handle the foot controller with care and avoid dropping it on the floor. Be sure not to place

anything on top of it when not in use.

* Disconnect the powerline plug from the electric outlet when changing needles, presser feet or

throat plates, or when leaving the machine unattended. This eliminates the possibility of starting
the machine by accidentally pressing the controller.

* Before‘cleaning your machine, disconnect the powerHne plug from the electric outlet.

7.

SETTING UP THE THREAD GUIDE

HOLDER

* This machine is shipped with the thread guide

holder in the lowered position.

* Fully extend the thread guide holder.

* The two joints on the telescope will cHck into

place when they are correctly positioned.

Center the thread guides above the spool pins.

* Place thread over the cone adapters on the spool

pins.

Note:

If the machine is threaded, straighten the

threads to prevent tangling.

Advertising
This manual is related to the following products: