The set of hemmers, 74 , and 75 – SINGER W712 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
35
THE SET OF HEMMERS
■
Before
attaching any of the hemmers, be sure
bobbin thread
is pulled up. Then, with hemmer in
place,'hold top
thread loosely and turn handwheel one
full, turn toward
you, making a loop under hemmer.
. Grasp bobbin
: thread with both hands and slip
'■ horizontally
under hemmer toward back. Bobbin
thread will catch
loop and carry upper thread to back
of heramer. .
'
_ , Fold material'
to suit for two inches along edge,
i
'hold-at each end of
Toldr Slip fold into guide and
' , up over spoon. (Fig.
69). Fold hem in material back of hemmer.
’- --S'
V
-and Fasten with point of
"needle. Pull on threads gently as you start stitching
Fig. 69
Draw forward to end of hem
' H E M M E R S E T
_ g You can make a hem 1/4T 3/8T 5/8"
or
7/8"
in width, depending upon
, which.bemmer you use.
For a few of the many uses see Figs. 70, 71, 72, 73,
74, and 75.
/
-
-
,
•'
■ ■ , ■ ■ ■ ' . / ■ ' I