SINGER W1665 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
28
your
a
(2
(3
HOW TO CHANGE THE BELT
If it should ever become necessary to replace the belt on
machine, proceed as follows:
Remove screws A (Fig. 63).
Remove rear cover.
Remove clutch nut B in center of hand wheel (Fig. 63)
by taking out small screw C. Turn nut counter-clockwise
by holding the take-up lever until it can be lifted off.
Before moving hand wheel, note position of lips on washer
D (Fig. 64j as it will fall off when changing the belt.
Slide old belt over motor pulley E (Fig. 64).
(6)
Pull hand wheel away from
machine just far enough to
allow the belt to slip over
wheel.
(7)
Put
new
belt
in
grooved
section
of
hand
wheel
and
then over motor pulley.
(8)
Replace washer D in original
position.
(9)
Replace clutch nut and
screw C. After doing this,
turn clutch toward you to
disengage sewing mechanism.
If the needle still moves up
and down as you turn the
hand wheel, again remove the
clutch nut, give washer D a
half turn and replace the nut.
(10) Replace rear cover.
Fig. 65