SINGER W1213 - Manual (Page 38)

Using a sewing machine oil, place a
single drop on each oiling point as
illustrated, specifically those points
marked in red on your machine.
(Fig. 140) Run the machine to allow
the oil to penetrate.
After you have finished oiling the
machine replace the bobbin case by
placing case into the machine and
pushing toward the left until the
grooves fit. (Fig. 141) Place the screw­
driver to the right of the black bracket
and force it toward the left and down.
To test bobbin case for correct place­
ment, place thumb in center of the
case and pull toward the right. The
black bracket and bobbin case should
remain in place.
The needle plate should then be
placed into its normal position and
the screws tightened, then the presser
foot and needle are replaced.
(pages 9 &14)
141 142
4. Changing the Light Bulb
Open the'^face plate by pulling towards the
left. Turn the light bulb counterclockwise to
remove. Replace the bulb by turning clock­
wise. (Fig. 142)
A majority of service calls could be avoided
by foUowing the above procedures and by
first checking to see that the machine is;
1. Threaded properly.
2. That the bobbin is wound evenly.
3. That the needle is in the machine
correctly.
36