SINGER W1213 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Upper Threading
1.
Turn hand wheel toward you to raise the
take-up lever to its highest position. Presser
foot should be in the raised position.
2.
Lead thread from the spool as illustrated,
(Fig. 22) being sure to place the spool cap
so that it holds the spool securely. Draw
the
thread
between
the
tension
discs
and
around
toward
the
right
until
it
emerges
under the finger like projection. Bring the
thread
through
the
succeeding
points
as
illustrated. Thread the needle from
front to
back
and leave the thread about three or
four inches long. (Fig. 27)
3.
Hold upper thread down on slide plate and
turn hand wheel toward you one complete
revolution.
Pull
the
loop
which
has
been
formed through to the upper surface. (Fig.
28)
Place
both
thread
ends
under
the
presser
foot and draw them toward either the right
or
left
leaving
both
threads
about
four
inches long. (Fig.29)
27
28
r
29