Operating machine, Connecting machine – SINGER 1280 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operating Machine
Connecting Machine
Before plugging in your machine, be sure that the volt*
age and number of cycles indicated on the electrical
nameplate A, conform to your electrical power supply.
If your speed controller cord has a motor dIscon*
nect plug, push plug B into the receptacle at the right
end of machine. Then connect plug C to your socket
outlet.
If the speed controller cord is wired directly to the
motor, simply connect plug C to your socket outlet.
CAUTION: Disconnect the power line plug from the
socket outlet when changing needles, feel or needle
plates or when leaving the machine unattended. This
eliminates the possiPility of starting the machine by
accidentally pressing the speed controller
If your machine has a sewing light switch, press or
turn
switch on the machine, as
required.
If machine has a three-position switch:
• The OFF setting {switch moved to 0 symbol).
• The MIN, setting {switch moved to I symibol) al
lows the maximum control for special jobs.
•
The
MAX, setting (switch moved to 11 symbol) ah
lows for full speed capacity of the
machine.
To run the machine and control speed, press the
speed controller 0 with your foot. The
harder
you
press, the
faster
the
machme
wi sew. To stop ma
chine. remove foot from controller.
CAUTION: Because of the up and down movement
of the needle, you must work carefully and watch the
sewing area when operating the machine.
18