SINGER 1280 User Manual
Page 79
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To clean y andoH ® the front intenor of machine,
remove screw from face piate. With a soft cioth or Hnt
brush, clean and oil points indicated by arrows. Re*
place face plate and screw.
To clean bobbin and feed areas, remove needle plate,
as instructed on page 14 . Remove 'Dobbin case as m*
structed on next page. Using soft cloth or brush, clean
area as illustrated. Replace needle plate and bobbin
case, as instructed on pages 14 and 80.
if necessary, a mild solution of soap and water may be
used on exterior areas to remove stubborn stains. No
other
cleaning
iiquic or powder should be used.
I:
Do not attempt to adjust the motor pelt.
Contact your nearest Service Centre should any ad-
justment be reQuired.
78