The bobbin thread, Winding the bobbin, Preparation steps – SINGER 1280 User Manual

Page 21: Winding steps

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

The Bobbin Thread

Winding the Bobbin

Preparation Steps

1. Raise the presser foot and turn hand wheei toward

you until needle is in highest position.

Z* Loosen hand wheel knob A by turning it toward you

with the right hand while holding hand wheel with
the left hand.

3. Place thread spool on spool pin with

thread

retain­

ing silt B to the right. (Break paper at the end of
spool if necessary,)

• Place spool

holder

C

on spool pin and press

firmly

against the thread spooi.

Winding Steps

• Snap thread into

thread

guide post D and open top

cover.

• Lead thread around bobbin

v^inder

tension disc E,

as illustrated, and through small hole in bobbin from

inside out.

• Place bobbin on spindle and move bobbin wmder

F to right.

• Hold

thread

end and start the machine. Cut off

thread end after a few coils have been wound.

• When reouired amount of thread has been wound

(winding will stop when bobbin is full) stop machine
and cut connecting thread.

• Move bobbin winder to the left and remove bobbin,

• Hold hand wheel and tighten hand wheel knob.

Advertising