Threading the bobbin case – SINGER 1280 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Threading the Bobbin Case
1 Hold bobbin $0 tha* thread unwinds in direction
shown, and insert bobbin m bobbin case.
2. Puli thread mto notch A
\n
bobbin case, draw h
toward left and into slot
8
.
3. Draw approximately I0cm (4 inches) of thread diag
onally across the bobbin.
4 Close slide plate, allowing thread to extend through
the slot between the slide plate and the needle plate.
22
Advertising