Sewing light, Foot control, Electronic speed controller – SINGER W1550 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ELECTRONIC SPEED CONTROLLER
Push the speed control plug onto three
prong connector.
Plug machine cord into any 110 ~ 120
volt wall outlet.
Turn light on and off by pushing light
switch.
SEWING LIGHT
The sewing light is located in the face
cover as shown. To replace the bulb,
turn the light off and open the face
cover. Push the bulb up and turn the
bulb counter-clockwise and remove d
from the socket.
Push a new bulb m and turn it clockwise.
NOTE:
First, unplug the machine prior to re
moving and replacing the bulb. Be
aware that the light bulb may be warm.
FOOT CONTROL
Step on this control to start tosew. The
harder you press on the control, the
faster the machine will sew. Slow down
by reducing foot pressure on the control.
You may want to practice your speed at
different levels when you first use the
machine.