SINGER W1550 - Manual (Page 16)

1
ADJUSTING BOBBIN WINDER
- - - - -
■
. -
■ , ■
-
':y
■ I
I
1
Correct
Incorrect
Incorrect
Bobbin winder thread guide
Fixing screw
The thread must be wound onto the bobbin
evenly.
If the thread piles up at the bottom, loosen
the fixing screw of the winder tpruipn and
set the tension a little higher.
If more thread is wound on at the top of the
bobbin, push the winder tension down a
little.
After adjustment, do not forget to tighten
the fixing screw!
To locate fixing screw, open face plate. This
screw is directly under bobbin winder thread
guide inside the top cover.
Set the winder stop so that the bobbin is
filled to about % with thread. The bobbin
must stop turning when the required amount
of thread is wound. If the amount of
thread is not correct, loosen the screw and
move the winder stop as shown in the
illustration at the right.
bobbin
winder
stopper
LESS MORE
12
/