Shaping darts in interfacings – SINGER W1366 User Manual

Page 45

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

44

SHAPING DARTS IN INTERFACINGS

3

Center

Fig. 94

Fig. 95

Cut interfacing down center between dart lines.

Overlap cut edges,' matching dart lines. Zigzag stitch

along marking line from point to wide end oi dart.
Trim both raw edges close to stitching.

Most fabrics need to be guided only in front of the presser foot as shown at

sheers crepes, knits, tricots, etc., require support while being stitched. For such fabric use the
straight stitch throat plate and presser foot and apply gentle tension by holding seam in front an
back of the presser foot as shown at right.

Advertising