Overcasting worn edges, Patching, Straight or three cornered tear – SINGER W1366 User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
45
OVERCASTING WORN EDGES
Zigzag stitch along the worn edges, catching the fabric as
the needle swings to the left, and allowing the needle to just
pass over the edge of the fabric on the right (Fig. 98).
PATCHING
Machine baste patch into
place under hole or worn
area which has been cut away.
Then zigzag stitch the patch
into
place
by
overcasting
around edge of hole (Fig. 99).
Fig. 99
STRAIGHT OR THREE CORNERED TEAR
Zigzag stitch along a straight tear catching fabric on left
and right side of tear by swing of needle. Ee sure your
tensions are not too tight or puckering will be encountered.
In mending a three cornered tear, zigzag stitch from each
end to center (Fig. 100).
Fie, 98
Fig. 100