2) thread the left looper (yellow path) – SINGER 14U52 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Remove cylinder cover and thread left looper in the order 0 to

path) (See page 8 for cylinder cover removal)

While holding thread with finger, wrap

thread around tension disk clockwise

till

caught in hook and pull thread

down to make certain it is properly

located in between the tension discs.

(2) Thread the left looper (yellow path)

shown below. (Yellow thread

Turn hand wheel toward you

until left looper is at left as far

as it will go and thread the

looper thread hole (9) from left

to right. (Use tweezers provided

in your accessory set).

Turn hand wheel toward you

until the looper is at right as far

as it will go passing the thread

under the throat plate, then

using the tweezers, thread the

looper thread hole (f^ from

front to back.

Place the thread over the top of the right looper and

hold the thread while initially sewing.

11

Advertising
This manual is related to the following products: