Preparation for threading, Setting up the thread guide holder, How to insert the needles – SINGER 14U52 User Manual

Page 9: To remove the needles, To replace the needle

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

5. Preparation for threading

• Setting up the thread guide holder

Extend the thread guide holder as far as possible

and set the thread guides so that they are located

right above the spool pins.

Place the thread on the spool stand as sho^vn

above.

• How to insert the needles

Use Singer needles Cat. No. 2054 available in sizes #14 and (#10)

To remove the needles:

• Be sure the power line plug is disconnected from the wall receptacle.

• Turn the hand wheel toward you until the needle is at its highest

position. Loosen the needle set screw with a screwdriver and remove

needles.

To replace the needle:

• Insert the needles into the needle bar hole as far as they will go with

flat surface to the rear and securely tighten the needle set screw.

Remove

Flat surface to the rear

Note: When both the left and right needles are inserted, the left needle will be slightly higher than

the right.

Advertising
This manual is related to the following products: