SINGER W614 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
) i
BOBBIN: CASE
,-ig. 12
Raise needle bar to highest position, and lift hinged
cover plate. ( S e e 1 6 Fig. 1 ) Hold the bobbin case
latch
(D,
rig.
12),
between
the
thumb
and
forefinger
of the left hand, with at least three inches of thread
running from the top of the bobbin case to the right.
Insert and center the bobbin case on the stud of the
shuttle body, ( C ) . Be sure the bobbin case finger lE)
is opposite the shuttle race notch, ( A ) . Press the
bobbin case (B) into the shuttle as far as possible
until latch catches on the center post of the shuttle.
Then release the bobbin case latch, ( D ) . Press bob
bin case again after latch has been released to make
sure the bobbin case is locked securely.
Close the cover plate.