SINGER W614 - Manual (Page 22)

lEOLES-UPPER THREAOIM'G AfiD S E W I N G
■l Be sure zigzag needle plate and presser foot are in place.
2 Set needle position control 5 Fig.-25B at twin needle position. Tnis will s e t a stop
to prevent the zigzag width control moving beyond the number 3 position.
;j.. ,-o,,uv/ oj,'d..ioi/)g instructions for single needle with these exceptions;
a. place, two spools of thread, matching or contrasting in color, one on each spool
pin. ’
b. Lead both threads through arm thread guides.
c. Bring threads down and around tension discs with one thread passing between the
back discs and the other between the front discs.
:/dai both threads as one until you reach the needle eye.
"'/w :r;.> b'r-.'id through each needle eye(Fig. 2 6 ) .
4 . T h a rnaxirnurn zigzag stitch width that can be sewn when using twin
needle is at t h e number 3 setting of the zigzag width control.
Any position above the number 3 position will break the twin needle.
5. Straight stitching and decorative stitch designs can be produced
in the same manner as for single needle sewing except for the
maximum zigzag width.