SINGER W614 - Manual (Page 28)

2 7
SEWING ON BUTTONS
, He., u va presser foot and replace with special purpose button sewing
foot iFig. 36 ) ,
y . , , , '-‘DN” position ¡'.Fig- 3 5 ) .
3 Set zigzag width control at "0” ^ i «vi"
, Set needle position control at “L” and decorative stitch dial a. .Vi
Place the button so that its left hole comes directly under the presser
the zigzag width control to produce a zigzag stitch until the
"" needle enters the right hand hole of the button. Turn the balance
wheel slowly by hand to be sure the needle clears both holes in the
button. Correct width if necessary.
g When needle goes into the center of each hole, run the macfiins at
* a medium speed, making five or six stitches, stopping with the needle
in the left hole.
7. To lock the zigzag stitch and prevent ravelling,
set the zigzag stitch width control to 0 (remem­
bering its original setting i and take a few stitches
in the same hole. If you wish, you may place a
rounded toothpick over the button between the
two holes, and sew button to fabric in the regular
way. Remove the tooth-nick end wind th-read under
button forming a shank to fasten.
Fig. 36