SINGER W614 - Manual (Page 25)

EMBROIDERING WITH A HOOP
it 13^ easy to follow a stamped design or to
wui A ras l a n d when embroidering or mono-
gramfuing. (See Fig. 29) Release the prassurs
from the foot by pressing down the snap lock
on the darner. Turn the drop feed knob to
"DN” position (See Fig. 2 9 ) .
oireicn ine fabric in an embroidery hoop, and
place under the needle after removing the
prnssar foot. Set the stitch width at the size
you prefer and lower the presser bar lifter.
Then operate the machine at a rather high
speed while moving the hoop slowly with
both hands. Work carefully and be sure to keep fingers out of the path of the needle
Should you encounter skip stitches the fabric is not stretched tight enough or a darning
spring is needed (see attachments avaiiabte from yourdeaJer illustrated in the back of
this book).