Selecting a pattern group, Adjusting width of the design, Stitch width selector – SINGER 6136 User Manual
Page 27: Adjusting stitch placement
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SELECTING A PATTERN GROUP
Before moving pattern group solecior, make
sure noodle is above fabric.
When you rotate the pattern group i>elector,
one of six different groups of stitch pattern is
cwailable to you.
Slide stitch width selector to | . then rotate
the pattern group selector as required, until
the number of the desired group of two stitches
is positioned under the V symbol above the
sotector.
-•j
Б г
ADJUSTING WIDTH OF THE DESIGN
Before moving stitch width selector, always
raise needle above fabric.
To produce a stitch pattern, thp stitch width
selector must be moved from j toward the
right. The further you move the selector lever
toward the right, the wider your stitch will be.
ru
Stitch Width Selector
ADJUSTING STITCH PLACEMENT
Before moving needle position sofcctor, make
sure needle is above fabric.
ЛИ stitch patterns can be sewn in either left
i* , centre X , or right Д needle position
Selector setting centre X >s used most often.
A
left or J, right setting is used to
place narrow stitch patterns to the left or right
of the centre in decorative work.
Loft
Centro
Right
26