Removing and replacing needle, Plate, Attaching snap-in feed cover – SINGER 6136 User Manual
Page 7: Attaching blindstitch hem guide
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING AND REPLACING NEEDLE
PLATE
• Raise pressor foot.
• Raise needle to highest position.
• Open slide plate. Place thumb under right
side of needle plate, lift it up and withdraw
it to right.
• Replace needle plate under clamping pin A.
push it gently to the left and press down
until it snaps Into place.
A
ATTACHING SNAP-IN FEED COVER
• Ftaise presser foot.
• Raise needle to highest position by turning
hand wheel toward you. Open slide plate.
• Slide snap-in feed cover away from you
over needle plate until points B and C are
positioned directly over holes in needle plate
as illustrated. Snap in point B. Then push
point C in toward point B until it snaps into
place. Close slide plate. To remove, open
slide plate then simply lift up front edge of
feed cover.
...c
ATTACHING BLINDSTITCH HEM GUIDE
• Raise presser foot, loosen presser foot
screw with a coin and slip blindstitch hem
guide between screw and shank of the
general purpose foot.
• Be sure underside of the guide clears the
slide plate and front of foot.
•
• Tighten screw with a coin.