SINGER W6105 - Manual (Page 23)

UAKIMINÜ
Machine Setting
Fresser Stitch Stitch Stifeh Fabric
I'oot Pattern Width Length Feed
1
- / \
Darn Sew
# __
None
llJuiil Rc^’Uiar .Sliftili
Slit.It Slilch Shkii
( J ( /
O ■
0
Worn spots on clothing and household
linens can be darned easily with your
machine.
Completely release pressure on fabric
by pushing down DARN button and
by pressing down on outer ring of
pressure regulator until center button
pops up.
For greater control, especially when
darning larger areas, place fabric in
embroidery hoop. For large holes,
baste a piece of mending material
underneath hole to use as a base for
stitching.
Place fabric under needle. Move fabric
back and forth with an even motion to
cover darning area with closely spaced
rows of stitching. Then turn fabric and
sew a second layer of stitching across
first layer of stitching.
41
PAH I 111 CAHIIMG FOR YOUR MACHINE
CLEANING
Your machine will always work well
you take a few moments to keep
clean. If lint and bits of thread a«
cumulate under needle plate, aroun
fabric feed and in the shuttle, this wi
interfere with the operation of yoi
machine. Check occasionally and clea
whenever necessary.
• Before cleaning, disconnect cor
from outlet.
• Remove needle, presser foot, needl
plate and slide plate.
• To remove shuttle: raise needle be
to its highest position and remov
bobbin case. Turn levers away frot
shuttle and lift our retaining tin
and shuttle, by grasping center pin.
• Thoroughly clean under fabric feet
with a small brush. Remove lint am
thread from all parts of shuttle ani
wipe with a lightly oiled cloth.
• To reassemble: hold shuttle b;
center pin, and fit carefully bac
into shuttle race, forming perfec
circle with driver. Replace retainin
ring, polished side out, making sur
the bottom pin fits into notcl
Lock retaining ring by tumin
levers back into position until the
snap over the two small post;
Replace bobbin and case.