SINGER W6105 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

REMOVING BOBBIN CASE

K;iise needle to its highest position by

lurning hand wheel toward you. Pull

slide plate out to the left.

I,ill open hinged latch ol bobbin case

and pull case toward the left and out
of machine.

Bobbin will remain in case as long as

atch is open. 1 o remove bobbin, hold

bobbin case down, close latch and
bobbin will fall out.

THREADING BOBBIN CASE

Hold bobbin us shown in illustration

so that thread goes over top of bobbin

and away from you.

Пасе bobbin in case withoul turning

it around.

Slide tliread into slot in edge of case

and draw thread under tension spring.

Pull out thread to check that bobbin

turns clockwise.

INSERTING BOBBIN CASE

Be sure that 5 to 6 inches of thread

extends out of bobbin.

Hold bobbin case so long finger on

case points up. Open out latch.

Slip case over holder post in shuttle

and press in place until finger enters
notch. Release latch.

Close slide plate.

BRINGING UP LOWER THREAD

'1

Raise presser foot. Hold needle thread

loosely with your left hand. Turn hand

wheel toward you until needle moves

down and then up again to its higliest

irosition, catching bobbin thread and

bringing it up through hole in needle
|)late.

^

I

d

prevent thread from slipping out

of needle when you begin sewing, pull

both thread out about 6” and place

under presser foot toward rear of
machine.

Advertising