SINGER 251 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
28
TO REMOVE THE SEWING HOOK
143350
S2ZH2
F2
Fig. 45. Removing Sewing Hook
Fig. 46. Replacing Oil Filter
Remove
the
needle,
slide
plate,
throat
plate
and
bobbin case. Remove the screw
D2, Fig. 45
and the
bobbin case holder position bracket
E2, Fig. 45.
Loosen
the two set screws
X, Fig. 45
in the hub of the hook
and turn the machine pulley over toward the oper
ator until the feed bar
C2
is raised to its
highest
point.
Turn the sewing hook until the thread guard
F2,
is
at the
bottom,
as shown in
Fig. 46.
Turn the bobbin
case holder
G2, Fig. 46
until the notch
J2
is also near
the bottom, as shown in
Figs. 46
and
47.
The sewing
hook can then be removed from the hook shaft.
TO REPLACE OIL FILTER 143350
While the sewing hook is off the shaft, it is advis
able
to replace the oil filter 143350, Fig. 46,
in the
end of the hook shaft. Unscrew the filter from the
center of the shaft at
H2, Fig. 46
and replace with
cl
complete new filter
143350.