To remove the bobbin from bobbin case, To attach the bobbin case, Changing the bobbin – SINGER W811 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING THE BOBBIN
TO REMOVE THE BOBBIN FROM BOBBIN CASE:
•
Raise needle bar to its highest position. Bobbin case cannot be
removed when needle bar is at low position.
•
Open shuttle race cover, pull bobbin case latch with two fingers and
remove bobbin case as shown above.
•
Remove bobbin from bobbin case by releasing latch.
Re(
anc
Th(
Th(
Sei
Mo
Ret
TO ATTACH THE BOBBIN CASE:
•
Pull thread at least 3 inches from bobbin.
•
Thread bobbin as shown on page) 7 ).
•
Making
sure
that
needle
bar
is
at
its
highest
position,
insert
bobbin
case
into
shuttle
race
by
holding
bobbin
case
latch.
Make
sure
bob
bin
case
finger
is
inside
shuttle
notch.
Press
bobbin
case
into
shuttle
as far as possible until latch catches on center post of the shuttle.