Replacing bobbin case, Threading machine – SINGER W130 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

8. REPLACING BOBBIN CASE

1. Turn fly wheel toward you by hand

until the needle bar is at its highest •

position, and open the slide plate.

Draw about 3 inches of thread from
the bobbin and let it hang loosely

from the bobbin case.

2. With the left thumb and forefinger,

hold the latch ( A ) of tlie bobbin case
(B) and place it on the spindle post

(C) . (Fig. 6)

NOTE : The protruding finger (D)

must slide into the delivery eye (E)

at the top of the shuttle.

3. Release the latch and press the bobbin

case to the right until it catches the

groove on the spindle post.

9. T H R E A D I N G M A C H I N E

1. Turn the fly wheel toward you and

raise the take up lever (E) to its highest

position. Place thread on the spool pin

and bring the thread through the upper

thread guide ( A ) .

2 . Bring the thread down through the

thread guide to the tension disc (B)

from right to left and up. Then pull

the thread up through the thread take

up spring (C).

3.

Bring the thread under the thread

tension guide (D) and thread the take

up lever (E) from right to left.

4. Bring thread down througli the thread

guide (F) at the opening in the face

plate, and through the needle bar

thread guide (G) from behind. Thread
the needle from left to right, leaving

about 5 or 6 inches of thread.

Fig. 16

F ig. 17

Advertising