Prepabing to sew – SINGER W130 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10. PREPABiNG TO SEW
1. Hold the loose end of the needle thread
in your left hand, and turn the tly
wheel toward you by hand until the
needle moves down through the needle
plate and up again to its highest position.
Pull the needle thread gently, and the
bobbin thread will come up with it
through the hole in the needle plate.
Then place both ends of the thread
back between the toes of the presser foot.
N O T E : It the bobbin thread does
not rise, check to see if there is at
least 3 or 4 inches of bobbin thread
hanging loosely from the bobbin case.
2. Pull the two threads at least 5 inches
behind the presser foot. Place material
under presser foot, and lower the foot
with the presser bar lifter. Regulate
the stitch to the desired size and sew.
TO REMOVE MATERIAL, raise the
needle to its highest position and raise
the foot with the presser bar lifter, then
pul! the fabric back and to the left.
Cut the thread with the thread cuitcr
behind presser bar, leaving a few indies
of thread behind the presser foot.