SINGER W1415 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
T H ñ E A D liS iG T H E B O B B IN
CASE
Hold the bobbin between the thumb and forefinger of your right
hand and pull off about 15 cm
(6
inches).of thread. ^
^
1, Hold the bobbin case in your left hand as shown and place
the filled bobbin inside.
2. Pull the thread into the slot in the edge of .the bobbin case.
.bobbtfv--G&seu
bobbin
Now pull the thread under the tension spring and into the
thread eyelet.
To insert the bobbin case and bobbin ......
Make sure that about 15 cm or
6
inches of thread extends
out of bobbin. Hold the bobbin cáse so that the long
finger on the case points up. Open the latch of the bobbin case.
Slip the bobbin case over the center pin of hook and press in
place until long finger of the bobbin case enters notch.
Release latch and press down.
__ ^
long finger notch
i- latch
.1 5 -