Instructions for portable installation – SINGER W1222 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
24
INSTRUCTIONS FOR PORTABLE INSTALLATION
Please read these important instructions which were written to aid you in placing your new
sewing machine on its portable base.
After unpacking the sewing machine unit, being certain to take out the instruction book,
guarantee and accessory box, lay the unit face down on a table. You will see two clamping
screws A entering head hinge holes B on the underside of the back.
On the base you will find two head hinges C which will fit into holes B. Lower the base
onto the sewing machine fitting hinges C into holes B. Tighten screws A securely with a screw
driver.
With machine in sewing position attach plastic clamp D to top of partition with screw
provided so that it may be turned across the bed of the machine, to hold it down. (On some
bases the clamp may be positioned in the proper spot).
To make the electrical connection draw the two wires through the slot in the partition of
the base. Plug the cord labeled "Motor" into the receptacle marked "Motor" on the block
attached to the outer section of the base. Then insert the other cord into the "Light" receptacle.
Place the foot control on the floor, insert plug into a wall outlet (110-115 volts) and you
are ready to sew. But first read the instruction book to become familiar with the threading of
the
machine, tension adjustments and all the other features designed to make sewing a pleasure.