Upper threading – SINGER W1222 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UPPER THREADING
Turn hand wheel toward you to raise the
take-up lever and needle to their highest position.
Place spool of thread on spool pin and lead
thread through top plate thread guided) and(D.
Down and between tension discs® from right
to left.
Up and over the tension guide® then down
under the tension spring®
Into take-up lever ® from right to left.
Down through thread bar guide ® and into
face plate guide® and needle clamp guide®.
Thread needle from left to right pulling three
to four inches of thread through needle.
Hold the end of the upper thread loosey and
turn hand wheel toward you until the needle goes
all the way down and comes back up bringing with
it the bottom or bobbin case thread.
I
Place both threads
(upper and lower)
under the slot of the
Presser foot and place
toward the back of the
machine, leaving both
threads three to four
inches long.