SINGER 29K73 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO THREAD NEEDLE FOR DARNING
10
1.
Place the spool of thread on the spool pin so
that thread will draw from rear side of spool.
2.
Raise the wire guide in the oil cup on top of the
arm and pass thread under guide 1 then press guide
back into position. See Fig. 19.
3.
Pass thread over the pin 2 near the tension
discs in front of the arm and from right to left under
and between the tension discs 3, Fig. 21.
4.
Pass thread through wire eyelet 4.
5.
Pass thread up and from front to back through
the hole 5 in the take-up lever.
6.
Draw about 10 inches of thread through the
hole in take-up lever and insert the end into the slit
in
the
end
of
the
threading
wire supplied
with the
machine.
Then
pass
end
of
threading
wire
down
through hole 6 which runs through the center of the
needle bar.
7.
Remove thread from threading wire then with
draw
threading
wire.
Pass
the
thread
from
left
to
right through the eye of the needle 7. Draw about
three inches of thread through the eye of the needle
with which to start darning. ,
Fig. 22. Drowing up Bobbin Thread
the bobbin thread; draw up the needle thread and the
bobbin thread will come up with it through the hole
in the needle plate. See Fig. 22. Lay both threads back
under the feeding foot.
NOTE:
Turn
top
of
hand
wheel
over
toward
the
right (clockwise) if hand wheel is fitted on front of
machine.
TO START SEWING
Place the material under the feeding foot, lower the
foot and start to sew, turning the hand wheel over
toward you. (Turn hand wheel to the right if located
on front of machine.)
CAUTION: Do not try to help feeding of the work
by pulling the material as this may deflect the needle
and cause it to break. The machine feeds the work
easily without any assistance.
TO PREPARE FOR SEWING
TO REMOVE THE WORK
With the left hand hold the end of the needle thread,
leaving it slack from thé hand to the needle. Turn top
of hand wheel over toward you until the needle moves
down and up again to its highest point, thus catching
Let the needle bar rest at its highest point, raise the
feeding
foot,
then
draw
the
material
backward
about
3 inches and cut the threads close to the work. Leave
the ends of the threads under the feeding foot.