Placing bobbin case in shuttle, Upper threading (fig. 10) – SINGER W7911 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10
PLACING BOBBIN
CASE IN SHUTTLE
Raise needle bar to high
est position, and lift hing
ed
cover
plate.
(See
10,
10, Fig. 1.) Hold the bob
bin case latch, (D), Fig. 9,
between
the
thumb
and
forefinger of the left hand,
with
at
least
three
inches
of thread running from the top of the bobbin case
to
the right.
Insert and
center the
bobbin case on
the stud of the shuttle body, (C). Be sure the bob
bin
case
finger,
(E),
is
opposite
the
shuttle
race
notch,
(A).
Press
the
bobbin
case
(B)
into
the
shuttle as far as possible until latch catches on the
center post of the shuttle. THEN release the bobbin
case latch, (D). Press bobbin case again after latch
has been released to make sure the bobbin case is
locked securely in place. Close the cover plate.
UPPER THREADING (Fig. 10)
1) Place spool of thread on spool pin nearer the
needle.
2) Lead thread through upper thread guide A on
back of face plate.
3) Down and around tension discs B from back to
front
Fig. ID