Accessories – SINGER W7911 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
17
4.
5.
s
2
.
3.
Clean the shuttle race, the shuttle, and shuttle race
cover by removing all threads, lint, etc.
Apply a drop of oil with finger tip to outer edge
of shuttle.
When the cleaning has been completed, proceed as
follows to replace the shuttle assembly;
X. Turn the balance wheel until the needle reaches its
highest position.
Place shuttle body, (D), in race against shuttle driver.
shuttle race cover, -iC), over hinge pin at lower edge and lock into position with
into pStiom^
clamps, (B), making certain the clamps have been snap^d securely
4.
Put bobbin into bobbin case.
5.
Put the bobbin case into the shuttle race, fitting tongue into notch E of race cover
ACCESSORIES
’
25
1.
Plastic Oiler
(Sealed and filled)
2.
Package of Needles
3.
Large Screw Driver
4.
Small Screw Driver
5.
Felt washers (2)
(For spool pins)
6.
Bobbins (3)
I
o
5
o