Setting the stitch length – SINGER W7911 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
n
4) Into check spring C.
5) Then tug on thread to pull it into hook D 'see insert,
Fig. 10).
'
6) Up into take-up lever E from back to front.
7) Down into thread guide F on face plate.
8j Through the needle bar thread guide G.
9) Änd into needle from left to right. Pull three or four
inches of thread throngh needle.
Hold
the
end
of
upper
thread
loosely
and
turn
hand
wheel toward you until the needle gees all the way down
and comes back up. Ä loop (Fig. 11) will be formed over
the
upper
thread
which
then
can
be
pulled
out
straight.
Place both thread ends under the slot of the presser foot
and
draw
toward
the
back
of
the
machine,
leaving
both
threads three or four inches long.
SETTING THE STITCH LENGTH
The length of the stitch is regulated by the dial, shown
in Fig. 12. Near 0 is the shortest stitch and 5 is the long
est, but the dial may be set at any spot between the mark
ings for a variety of lengths. Turn the dial to the right to
length
and
to
the
left
to
shorten
the
stitch.
The
number
stitch
length
you
choose
is
indicated
by
the
triangular
pointer.
Fig. 11