Adjusting and changing “v” belt – SINGER W616 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTING AND CHANGING “V” BELT
2 9
f l
0
iniiii
-rnift
.4
Fig. 57
Fig. 58
Fig. 59
Following are the instructions for adjusting and changing the "V” belt;
)
Remove three screws holding rear cover
(Fig.
59
)
and fip it out
at
the bottom Then
pivoting around the hand wheel away from
the front
of the machine.
2)
To adjust V belt, loosen screws (A, Fig.
58) and
move bracket B up
to loosen bell and
down to tighten,
^3) To remove "V" bell:
(A)
Remove lop cover,
(B)
loosen screws A" (Fig. 58) and move bracket “
b
” to its highest position.
(C)
Slip bell off motor pulley and then over hand wheel.
(D)
Replace V bell by slipping it over hand wheel and then over motor pulley
(E)
Adjust as noted under No.
3
.