Upper threading – SINGER W616 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
UPPER THREADING
1.
Turn
the
hand
wheel
toward
you
to
raise
the
take-up lever to its highest position.
2. Place a spool of thread on the spool pin
3.
lead
the
thread
through
the
upper
arm
thread
guides.
4.
Run the thread through the thread guide bar to
the
tension
discs,
then
around
and
between
them
from right to left.
5.
Draw the thread up through the check spring
and with a slight tug into the hook, (See insert
Fig. 12)
6.
Pass the thread under the bar and up through
the eye of the take-up lever from right to left.
7.
Lead thread down under bar, through the face
plate
guides
and
then
through
the
needle
bar
guide from the back.
8.
Thread
needle
FROM
LEFT
TO
RIGHT,
drawing
it
through
about
3
or
4
inches.
Hold
the
end
of
the
upper
thread
loosely
and
turn
the
hand
wheel
toward
you
until
the
needle
goes
all
the
way
down
and
comes
back
up.
A
loop
(Fig
13) will be formed over the upper thread which
L "
straight. Place both
thread ends under the slot of the presser foot
and
draw
toward
the
back
of
the
machine,
leav
ing both threads three or four inches long
THREAD.
lUIDES
St
Vf
Fifl. 12
ir
b