Setting the needle, Threading the bobbin case – SINGER W616 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SETTING THE NEEDLE
Flat ^rlace
oi needle
shank
i]/
Fig. 6
See Fig. 6. Raise the needle bar to its highest
point, turning wheel toward you by hand.
Then
loosen
the
needle
clamp
screw
B
and
the
needle
can
be
inserted
into
clamp
C.
Place
needle
(flot side
. lo right) in the needle clamp and push it
upward
as
far
as
it
will
go
into
the
needle
clamp
hole,
tightening
the
needle
clamp
screw
securely
with'
a screw driver.
After changing the needle make one com
plete revolution of the balance wheel by hand pj
to be sure the needle is in the correct
^
position.
THREADING THE BOBBIN CASE
Step 1 (illustrated in Fig. 8). Hold bobbin case between thumb and forefinger of left hand
so that the slot in the edge of the
bobbin case is on top.
Take the bobbin between
thumb and’
forefinger of right hand so that the
thread on top leads from left to right.
Step 2. Insert bobbin into bobbin
case, pull the thread
into the slot of the bobbin case as
shown in Fig. 9. and draw it under
tension spring and into
the fork-shaped opening of
the spring
as shown in Fig. 10.