SINGER W1411 - Manual (Page 32)

HEMMING
Presser foot...........................................hemmer foot
Pattern selector.................................... M ( Ct) )
Stitch length dial...................................1 to 4
Raise the foot and the needle to its highest position. Replace the
foot with the hemmer foot.
Fbld over the fabric edge by about 3 mm (1/8 inches) and place it
under the foot. Secure the folded edge with a few stitches. Take
out the workpiece and draw the hem into the hemmer foot by
pulling on the threads.
Lower the foot and sew the hem.
During sewing, fold the fabric to the left a little and allow it to
run into the hemmer foot.
Make sure that the fabric does not move under the right half of
the foot. The fabric must be fed into the scroll of the hemmer
sufficiently so that the workpiece edge runs freely through the
groove under the foot.
hemmer foot
-
29
-