Changing the needle plate (a),(c), Attaching the feed cover (f), Removing the extension table (6212) – SINGER 6212 User Manual
Page 10: Changing the needle plate attaching the feed cover, Removing and replacing the extension table
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING THE NEEDLE PLATE (A),(C)
Your machine comes with the General Purpose Needle Plate (A) attached. The
Straight Stitch Needle Plate (C) may be purchased at your sewing center and can be
attached as follows:
• Raise needle and presser foot.
• Open slide plate.
• Lift up needle plate from right corner
and slide out from under foot.
•
To replace needle plate, slide it
under pin (1) and push it firmly to the
left.
• Press down until it snaps into place.
ATTACHING THE FEED COVER (F)
The feed cover is used to keep the feed from moving the fabric when attaching a
button, darning or sewing free-motion embroidery. To attach it, follow the directions
below;
Raise needle and presser foot.
Open slide plate.
Slide feed cover on top of needle
plate, pressing tabs (1) and (2) into
holes.
Close slide plate.
To remove, open slide plate and lift
front edge of cover; pull it away.
REMOVING THE EXTENSION TABLE (6212)
Free arm sewing makes it easier to sew hard-to-reach areas.
To change machine for free arm
sewing, lift right edge (1) of extension
table, slide it to the left and off the
machine.
To replace the extension table, slide
it to the right keeping it even with the
free arm, until the tabs on the right lock
into place.
8