Getting ready to sew, Important safeguards – SINGER 6212 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. GETTING READY TO SEW
IMPORTANT SAFEGUARDS
1. Disconnect the power-line plug from the socket outlet when changing
needies, feet, or needle plates, or when leaving the machine unat
tended. This eiiminates the possibility of starting the machine by
accidentally pressing the speed controller.
2. Before removing the bobbin case, disconnect the power-iine plug from
the socket outlet.
3. Because of the up and down movement of the needle, you must work
carefully and watch the sewing area when operating the machine.
4. Do not pull the fabric while you are stitching as this may deflect the
needle, causing it to break.
5. Before cleaning your machine, disconnect the power-line plug from the
socket outlet.
6. Do not attempt to adjust the motor belt. Contact your nearest Service
Center or an authorized Singer dealer should any adjustment be
required.
7. Before changing light bulb, make sure you have disconnected power
line plug from socket outlet. Be sure to replace the head end cover
which covers the light bulb before operating the machine.
8. This machine is designed to use a 15-watt maximum iight bulb.
9. This machine is double insulated. When servicing, use only identical
replacement parts.
This product is suppressed for radio and teievision interference with the
International Electro-technical Commission requirements of the CISPR.
Machines for Great Britain and some other countries having simiiar wiring
standards are shipped from the factory without a plug for connection to the
mains. The wires in this mains iead are coloured in accordance with the
foliowing code:
Biue: neutrai (N)
Brown: live (L)
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black. The wire which is coloured
brown must be connected to the terminal which is marked with the letter L or
coloured red. If a 13 Amp. (BS 1363) plug is used, a 3 Amp. fuse must be
fitted, or if any other type of piug is used, a 5 Amp. fuse must befitted either in
the plug or adaptor or at the distribution board.